Rules for self-changing oil in manual transmission nissan almera classic. Rules for self-changing oil in manual transmission nissan almera classic Oil change interval in automatic transmission nissan almera

Refueling volumes:

ICE oil5W-40 ke900-90042

2.7 l

Automatic transmission oil Matic-D ke908-99931

full filling volume - 7.7 l

partial filling volume - 4.5 l

Manual transmission oil XZ OIL 75W-80 ke916-99931

3.0 l

AntifreezeL248 ke902-99945

6.7 l

Brake Fluid DOT 4 ke903-99932

filling volume - 1 l

Hello everyone! After reading this article, you will learn how to change the oil in a Nissan Almera automatic transmission. The procedure requires certain skills, but if you delve a little into the course of work, then everything can be done independently and without trips to a car service. And those who have not yet, please read our article first. So let's get started.

What is required to change the oil in a Nissan Almera automatic transmission?

To change the oil in an automatic transmission Nissan Almera, we need a new transmission oil. It is advisable to take the original NISSAN ATF MATIC-D in the amount of 4 liters. you can search for part number KLE22-00004 or KE908-99931. If you can not find the original, then take an analogue. But first check the possibility of its application.

New automatic transmission filter Can be found under the article: 31728-31X01. We take the original or a high-quality double.

New transmission gasket. Article: 31397-31X02. As in the case of the filter, we take either a good take or the original!

Wrench 10". Best of all is the head, extension and collar.
13" socket and similar size cap.
Key for 22".
Carburetor cleaner (maybe the easiest).
Clean napkin, rags.
Flat screwdriver.
Knife for stripping old sealant.
Measuring canister, funnel, container for testing.

Oil change interval in automatic transmission Nissan Almera

The manufacturer recommends changing the oil Automatic Nissan Almera after 60 thousand kilometers or after 4 years, whichever comes first. If the car is used in difficult conditions, then the replacement interval can be reduced to 30 thousand km and 24 months, respectively.

The progress of the oil change in the automatic transmission Nissan Almera

We draw your attention to the fact that the replacement must be carried out on a warm engine. When working with oil, safety precautions must be observed, as burns can be obtained. In case of contact with the eyes and skin, immediately rinse the affected area with plenty of water.

1. So, we warmed up the engine to operating temperature and turned it off. Before starting work, the engine protection was previously removed, which prevented access to the automatic transmission.

2. Find the drain plug:

And we unscrew it with a pre-prepared key for 22 ". Nearby we keep a container for working out, into which we drain the ATF.

Approximately 3-3.5 liters of oil should drain.

3. We wrap the drain plug in place. You can even completely tighten it, we will not touch it anymore. If the drain plug washer is not very good condition it is best to replace it immediately. The issue price is 30 rubles, but this will save you from further problems such as oil leakage through the drain plug.

4. We unscrew the 10 "21 bolt around the perimeter of the automatic transmission pan with a 10" wrench.

5. With a flat screwdriver, pry off the pallet and remove it to the side.

6. We see the "guts" of the automatic transmission and oil filter which we need to remove.

7. The most unfortunate, in my opinion, in dismantling the Nissan Almera automatic transmission filter is the location of the nut on top of the valve body. And in order to remove the filter of the machine, you need to remove the entire valve body. Yes, it sounds scary, but there is nothing complicated here. just loosen all the valve body mounting bolts:

And along the way, we unscrew, if possible, all the bolts securing the box filter.

8. Disconnect the contact chip, as shown in the photo below.

9. Carefully remove the gearshift rod and completely unscrew all the valve body mounting bolts and remove it.

10. Here is the same nut, because of which the entire valve body had to be removed.

11. We remove the old filter and install a new one in its place.

12. We put the valve body with a new filter in place and stretch all the bolts. Since the bolts different sizes, then it is important to install each in its place. Therefore, when disassembling, try not to confuse them. Don't forget to connect the wire connector and install the shift shaft correctly!

13. We clean the automatic transmission pan from dirt. Using a knife, remove the remnants of the old gasket. We also clean the magnets, on which metal chips usually accumulate. Do not forget to clean the box itself from the old sealant.

14. We install the automatic transmission pan in place and gradually stretch all the bolts. In principle, all work under the car is completed. If there was a metal protection, then we install it in place and go into the engine compartment.

15. Next stage oil change in automatic transmission Nissan Almera is the filling of new transmission oil. We will do this through the dipstick hole, but for convenience, we will remove the air filter duct:

16. We take out the probe and insert a funnel into its hole.

17. Pour new oil into the box. You can safely fill in 3.5 - 4 liters of oil. Install the dipstick in place.

18. We sit in the salon and start the engine. We give a little work and begin to sort out the positions of the automatic transmission selector with a slight delay, while holding the brake pedal. Then let the engine warm up and turn it off.

19. check the oil level in the automatic transmission. We take out the dipstick and look at the level.

In this case, it should be closer to the upper mark ("HOT" mark, which means "hot", since we have already warmed up the engine to operating temperature). If there is not enough oil, then we add it, if there is a lot, then we just take a simple syringe and a dropper and pump out the required amount.

That's actually all! At this Nissan Almera automatic transmission oil change can be considered complete! Thank you for your attention and see you soon! And at the very end of the article you can watch a video in which everything is described and shown in great detail.

Don't forget to comment on the article!

Nissan Almera N16 is a B-class car aimed at the entry-level segment. The release of the model began in 2000. A platform hatchback called Pulsar was produced in the UK - for the European market, as well as some Asian countries. The sedan version known in Russia was assembled in Japan. In the home market, this modification was known as the bluebird Sylphy. The car received a platform created by the joint efforts of Renault and Nissan. Note that the same "trolley" was used to create Nissan models Primera and Almera Tino. Nissan Almera N16 could be purchased with gasoline engines volume of 1.5 and 1.8 liters, with a capacity of 90-115 Horse power. A 2.2-liter diesel unit (110 hp) was also available. In addition, the car was offered with a 1.5-liter dCi diesel engine manufactured by Renault. The motors were aggregated with a mechanical or automatic transmission.

In 2003, a restyled version was released, which remained practically unchanged compared to the Almera of the 2000 model. And yet, the developers changed the interior design, and also finalized undercarriage, and a 2.2-liter diesel engine boosted to 136 horsepower appeared in the engine range. This motor was aggregated with a mechanical six-speed gearbox. In 2006, the production of the Nissan Almera N16 was announced to be discontinued, but despite this, in 2002, the production of a similar car called the Renault-Samsung SM3 was launched in South Korea. This car began to be delivered to Russia in 2006, but under the name Nissan Almera Classic.

How much oil is needed for manual transmission Nissan Almera N16

Year of release (2000-2006)

• Oil in a manual transmission with an engine 1.5 - 2.8-3.0 liters.
• Oil in a manual transmission with a 1.8 engine - 2.8-3.0 liters.
• Oil in a manual transmission with a 2.2 engine - 2.8-3.0 liters.

What oil is required for manual transmission Nissan Almera N16

Year of release (2000-2006)

• Manual transmission oil with engine 1.5 - 75W80 GL-4, Nissan MT-XZ GL4 SAE 75W-80, Elf Trans Elf NFP 75W-80
• Manual transmission oil with engine 1.8 - 75W80 GL-4, Nissan MT-XZ GL4 SAE 75W-80, Elf Trans Elf NFP 75W-80
• Manual transmission oil with engine 2.2 - 75W80 GL-4, Nissan MT-XZ GL4 SAE 75W-80, Elf Trans Elf NFP 75W-80

The maintenance regulations prescribe the following: it is necessary to change the oil in a manual transmission every 80-90 thousand km. The type and specification of the oil that suits your car can be found in the instructions for your car.

Instructions for changing manual transmission oil in a Nissan car

Consider the replacement process on the example of a car Nissan Tiida. The whole process is best done in the pit.

1. Remove the protection of the engine and gearbox from the bottom of the car. In some cars, such protection may not be available, because. is optional equipment.

2. Now we inspect the box, check: the oil seal of the right axle shaft, the oil seal of the left axle shaft, the anthers of the axle shafts. They should not show signs of oil. May be wet with water, but should not be wet with gearbox oil.

3. This is what the drain plug looks like mechanical box gears:

4. This is what it looks like filler plug. It is also the oil level in the box:

5. Unscrew the manual transmission drain plug having prepared in advance and substituting a container under it to drain the oil. Wait until the oil is completely drained.

6. Replace the O-ring on the drain plug. This must be done so that the oil does not leak during further operation of the car. This is what the old and new seal rings look like:

7. Now take a filler syringe (available at an auto parts store) and a can of new oil and fill the gear oil into the syringe.

8. Insert the syringe tube into the filler hole and use the piston to pour oil into the box. You will need up to 3 liters of oil.

9. As we said above, the filler hole is also the level of oil volume in the manual transmission. Those. oil must be poured into the box until it runs back. As soon as the oil begins to slowly pour back from the filler hole of the box, this means that there is already enough oil in the box.

10. We twist the filler hole with a plug, put the protection back on the engine (if it was) and that's it.

This is how easy it is to change the oil in a manual transmission of Nissan cars.

Maintenance schedule for changing oil in a manual transmission

З - oil change in manual transmission

On a note

Many car owners of Nissan cars with a manual transmission cannot find a drain plug in their car. The thing is that this plug may look like an ordinary bolt. On the Nissan Maxima A32, the drain plug is located on the right under the drive inner CV joint.